HYDROSTOP SENSOR FOR SINGLE BRAKE CIRCUIT M10X1

The Idrostop sensor is essential to be able to replace the standard footboards with after-market footboards, usually without housing for the stop switch, thus allowing to keep the rear brake light on.

It is installed in place of one of the bolts in the circuit (normally the one on the pump) by connecting the two wires to the existing system.

The single version offers the possibility of connecting 1 hose to direct brake systems.

The Idrostop with male thread M10x1.25 is normally used on Japanese brake master cylinders, while the M10x1 version is used on Italian brake master cylinders (Brembo, Discacciati, etc.)