Front stand for steering head, in steel tubes, epoxy powder coating.
This model allows the disassembly of the front wheel and the fork legs and can be used with all motorcycles equipped with a perforated lower steering plate.
New model with pin fixing arm at an angle of 65 degrees of inclination.
Length of fixing arm from the center of the axle to the outside of the fork approx. 18 cm.
With this modification of arm inclination you avoid hitting against overhanging protrusions such as sports hulls or protruding beaks.
The package includes 7 pins with the following sizes:
N.1 pin diam. outside 27 mm
N.1 pin diam. outside 23 mm
N.1 pin diam. external 20 mm
N.1 pin diam. external 18 mm
N.1 pin diam. external 17 mm
N.1 pin diam. external 15 mm
N.1 pin diam. outside 13 mm
The pin for KTM motorcycles is also available (available separately) listed in the "Related Products" section, at the bottom of this page.
Watch the video of the FS-11 use by clicking HERE
Caution:
Motorcycles without a hole under the plate (such as some Ducati and MV Agusta models) require the use of the FS-11NEW model .
